This article explains how to format superscript and subscript text.

For more information about text blocks in general, please refer to these articles:

• How to Use the Title, Paragraph, and List Blocks
• Legacy Editor: Text Block

What Are Superscript and Subscript?

Subscript and superscript texts are when a part of a line of copy is either slightly higher or lower than the baseline text. Subscript is when the text appears below the baseline and superscript is when the text appears above it, as shown in the following example.

Superscript or Subscript Text in the Drag and Drop Editor

1. Navigate to your Campaigns tab.
2. Open a saved drag and drop draft or click on the Create new campaign button to create a new campaign from scratch.
3. Click on the Title, Paragraph, or List block in the right panel and drag it to the desired location in your mailing.
4. Enter your copy into the block.
5. Highlight the text that you want to make superscript or subscript.
6. In the text toolbar, click on the corresponding icon:
   • Superscript: To make the text superscript, click on the X² icon.
   • Subscript: To make the text subscript, click on the X₂ icon.

Superscript or Subscript Text in the Legacy Editor

When using our legacy* editor, it's easy to transform any part of your copy into subscript or superscript text, it just requires making a slight adjustment to the HTML of the text block that the copy is in.

1. Navigate to your Campaigns tab.
2. Open a saved legacy* draft or click on the Create new campaign button to choose a legacy* template.
3. Click on the text block icon in the left panel and drag it over to your mailing.
4. As you drag the block over to your campaign, you will see yellow sections appear labeled "Drop here". These yellow drop spots will turn green as you hover over them, so you know where the content block will appear in the mailing.
5. Once you release the block, it will appear in the place you designated.
6. Enter your copy into the text block.
7. In the toolbar at the top, click on the "</>" button to open the block's HTML code.
8. In the pop-up window, located the text you you want to make superscript or subscript and add the required tags on either side.
   • Superscript: <sup>Superscript copy goes here</sup>
   • Subscript: <sub>Subscript copy goes here</sub>

If you don't see the text transform right away in the legacy* editor, click on the Save button and then preview the campaign. If the text has not transformed, try sending yourself a test so that you can see how the text appears when delivered to your inbox. Sometimes the subscript formatting does not show right away or in the preview, but it will show in a test campaign, so always be sure it works properly by sending yourself a test first.

---

*In April 2022, Emma's legacy editor was replaced with a new drag and drop editor. Accounts that existed prior to this change still have access to the legacy editor through their previously saved templates and campaigns, however new, from-scratch campaigns can only be created in the new drag and drop editor. Accounts that were created after this change only have access to the new drag and drop editor. Please refer to our new editor FAQ article for more information.